In Figure 1, notice the EIGRP routing domain has three classful networks:

The output from R1’s show ip protocols command in Figure 2 shows that automatic summarization is now enabled. The output also indicates the networks that are summarized and on which interfaces. Notice that R1 summarizes two networks in its EIGRP routing updates:

R1 has the subnets and in its IPv4 routing table.

As indicated in Figure 3, R1 summarizes the and subnet. It forwards the summarized address of to its neighbors on its Serial 0/0/0 and GigabitEthernet 0/0 interfaces. Because R1 does not have any EIGRP neighbors on its GigabitEthernet 0/0 interface, the summarized routing update is only received by R2.

As indicated in Figure 4, R1 also has the,, and subnets in its IPv4 routing table. R3 selects R1 as the successor to because it has a lower feasible distance. The R3 S0/0/0 interface connecting to R1 uses a default bandwidth of 1,544 kb/s. The R3 link to R2 has a higher feasible distance because the R3 S0/0/1 interface has been configured with a lower bandwidth of 1,024 kb/s.

Notice that the summarized update is not sent out R1’s GigabitEthernet 0/0 and Serial 0/0/0 interfaces. This is because these two interfaces are members of the same class B network. The non-summarized routing update is sent by R1 to R2. Summarized updates are only sent out interfaces on different major classful networks.